01 / 06 · Sculpt and silicone
Read it from the tip down
Four parts make up the sculpt, listed here in order from the top.
Tapered tip
Narrow at the very top, and soft where it begins.
Defined head
Below the tip, a clear head with a ridge just underneath it.
Veined, curved shaft
Raised veins along its length and a thick middle. The shaft curves, a shape intended for G-spot or prostate play.
Textured testicles
At the base, sitting on the suction cup.
Two densities in one piece
The silicone is dual-density. On the outside is a soft layer with a skin-like feel; inside it, a firm core holds the shape. Press the shaft with a finger and the outer layer gives way until the finger reaches the core; chapter 2 has the studio clip.
Phthalate-free and latex-free, it is also odourless from the moment you unwrap it. Solid silicone runs right through it: no motor, no battery, nothing to charge.
Up close
Near the base the veins are still raised, and the testicles have a texture of their own. The shaft is narrower here, just above the testicles, than it is through the middle. The next chapter measures both.
Next02 · Size in four steps02 / 06 · Size in four steps
Length, width, core and base
As you scroll, the drawing changes four times, once for each step below: length, width, the inside, then the base.
- 1
Length: 8.85" end to end
Tip to base, the full length is 8.85" (22.5 cm), and 5.8" (14.7 cm) of it is insertable. The hatched part of the drawing, the testicles and the suction cup, stays outside.
- 2
Width: 2.56" at its widest
The shaft is widest through the middle: 2.56" (6.5 cm) in diameter, or 8" (20.3 cm) around. It narrows toward the base, and the lower ring, just above the testicles, measures 7" (17.8 cm).
- 3
Inside: a firm core
Beneath the soft outer layer is a core of firmer silicone. In the clip, a fingertip pushes into the side of the shaft, sinks into the surface and then meets the core.
Real footageStudio clip: a fingertip pressing the side of the shaft. - 4
Base: 3.23" and 2.7"
Near the bottom are the testicles, 3.23" (8.2 cm) across, and beneath them a 2.7" (6.9 cm) suction cup. Each is wider than the 2.56" shaft at its widest.
Measure what you already own
A tape measure makes the comparison easy. Wrap it around the thickest part of a toy you already use and compare with 8" (20.3 cm), or measure straight across and compare with 2.56" (6.5 cm).
A soft tailor's tape is simplest; a strip of paper marked with a pen works too.
Next03 · Cup and harness03 / 06 · Cup and harness
Hands-free, or in a harness
The base has two uses. Its 2.7" (6.9 cm) suction cup fixes the dildo to a surface so nobody has to hold it, and the same base can be worn in a strap-on harness.
What the cup needs
A smooth, flat surface, such as a glass shower wall or a bathroom floor. It will not grip anything textured or uneven.
- Glass
- Tile
- Tubs
- Floors
- Sex chairs
The cup is flexible: in the clip, a hand presses it and bends it.
Strap-on use
The base is harness-compatible, for use with an O-ring harness. The ring has to take a shaft 2.56" (6.5 cm) across, so measure the inside of yours before you rely on it.
Next04 · Starting out04 / 06 · Starting out
Before, during, and when to stop
For experienced users
Use it for anal or vaginal play once you have experience with toys this wide. New to the size? Begin with a slimmer one. Adults 18+ only.
- 01
Before
Wash it first. Silicone holds temperature, so you can warm it in warm water, or cool it, before you begin.
- 02
During
Use plenty of water-based lubricant and let the tapered tip go first. Take it slowly, and add more lubricant as you go rather than relying on the first coat.
- 03
If anything hurts
Stop straight away.
05 / 06 · Wash and dry
All of it goes under the tap
Nothing inside it is electronic, so there is no part to keep dry: you can hold every bit of it under a running tap.
Lubricant: water-based only
Silicone-based lubricant can harm the surface of this toy. Use a water-based one, every time.
- 01
Wash
Before and after each use: warm water with a mild soap, or a toy cleaner.
- 02
Rinse
Hold the whole toy under running water, suction cup included.
- 03
Dry
Let it air-dry completely, then store it away from children and pets.
06 / 06 · Specs, fit, FAQ
Check it against your list
Likely a fit if
- Toys around 2.56" (6.5 cm) wide are already familiar to you
- You choose by girth first and length second
- You want it fixed to glass, tile or a tub
- Your harness ring opens wide enough for 2.56"
Pick something else if
- Nothing you own comes close to this width
- You want vibration, or something to recharge
- You only use silicone-based lubricant
| Girth | 8" (20.3 cm) at the thickest point; 7" (17.8 cm) just above the testicles |
|---|---|
| Diameter | 2.56" (6.5 cm) at the widest |
| Overall length | 8.85" (22.5 cm) |
| Insertable | 5.8" (14.7 cm) |
| Testicles | Textured, 3.23" (8.2 cm) across |
| Suction cup | Flexible, 2.7" (6.9 cm) across |
| Harness | Compatible; needs a ring that takes 2.56" (6.5 cm) |
| Silicone | Dual density, soft outside and firm inside; phthalate-free, latex-free, odourless |
| Motor or battery | Neither; nothing to charge |
| Weight | About 690 g (1.52 lb) |
| Colour | Flesh |
| Age | Adults 18+ only |
Common questions
Is the 8" the length or the girth?
The girth. 8" (20.3 cm) is the distance around the thickest part of the shaft. In length it is 8.85" (22.5 cm) overall, with 5.8" (14.7 cm) insertable.
Can I use it in the shower?
Yes, if the wall is smooth and flat, like glass or tile, so the cup can hold. It is solid silicone with nothing electronic inside, so getting it wet is fine.
Does it need charging?
No. There is no motor and no battery.
Which harness works with it?
It needs an O-ring wide enough for a 2.56" (6.5 cm) shaft. Measure the ring of the harness you have, or plan to buy, before ordering.
Can it be warmed or cooled?
Both. Silicone keeps the temperature you give it, so a soak in warm water before use warms it, and it can be cooled too.
How heavy is it?
1.52 lb, which is about 690 g.
