01 / 06 · The silicone
Silicone with give in it
Pick it up and the whole length gives. Fold the ends up into a U, lift the middle into an arch, or work it into an S; release your grip and it lies straight again. No kink stays behind, and the silicone shows no cracks.
The material is solid silicone, non-porous and odorless.
- 01
The U
Both heads point up and the curve sits at the bottom, as in the desk clip below.
- 02
The arch
The middle rises and both ends curve down, as the studio clip shows.
- 03
The S
Two curves running in opposite directions along the length.
Warm days, same shape
That matters in Miami. Warm weather leaves this silicone as it was, even shut in a drawer, where TPE toys can turn soft or melt.
Up next02 · By the numbers02 / 06 · By the numbers
The size, one number at a time
Scroll and the drawing changes with each step: overall length, then the two halves meeting at the seam, then how thick it is, then what it weighs.
- 1
Overall: 19.7"
Lay it straight and it spans 19.7" (50 cm), from one head’s tip to the other’s. The desk clip below checks that with a tape measure.
Real footageTaped from tip to tip. - 2
Halved: 9.85" a side
Halfway along sits the molded seam, circled in the drawing. On either side of it is a realistic half of 9.85" (25 cm).
- 3
An even 1.7" across
The drawing marks the width near one head, at the seam and near the other head: 1.7" (4.3 cm) each time. The shaft runs straight, with no narrowing toward the ends.
- 4
Heft: 706 g
That comes to 24.9 oz, roughly 1.56 lb, of solid silicone, with nothing inside that needs power. The three small outlines in the drawing are the U, arch and S it bends into.
One check covers both ends
It assumes experience: you should already know which length and thickness are right for you. Because the width never changes, the same question applies to either end: is 1.7" (4.3 cm) a size you know works for you?
Up next03 · Heads and seam03 / 06 · Heads and seam
Two heads and the line between
Either end finishes in a realistic head with a defined, ridged glans. Veins stand out in relief down the shaft, whose surface is textured like skin. Each half measures 9.85" (25 cm) from tip to seam.
- Ridged glans
- Raised veins
- Skin-like surface
- Head at both ends

What the seam is
A molded seam circles the shaft at the halfway point, where the two halves join. That ring comes from the molding. It is not a crack or an opening, and the join has no gap.

04 / 06 · Shared or solo
Between two people, or just one
Two heads means two people can use it at the same moment, each with an end. It is for any couple, lesbian and gay couples among them, and for one person alone. Both ends suit anal or vaginal use.
Experience first
This is a long, flexible toy. Choose it only if you already know the length and thickness that suit you.
Take your time
Go slowly, most of all at the beginning.
Be generous with lube
Plenty of water-based lubricant on the end in use, topped up as needed.
Pain means stop
If anything hurts, stop there.
Both ends are heads
Neither end widens into a flared base. During anal play, keep a firm hand on it from start to finish.

05 / 06 · Keeping it clean
Rinse it whole, dry it fully
- 01
Wash, every time
Before you use it and again afterward, wash it with warm water and a mild soap, or with a toy cleaner.
- 02
All of it under the tap
Nothing inside is electronic, so you can hold the entire length under a running tap. Non-porous silicone rinses clean.
- 03
Dry, then store
Leave it to air-dry until no damp spot is left, then put it somewhere children and pets can’t get to.
The lube rule
Choose a water-based lubricant. Silicone-based lube can damage silicone toys, and this is one.
06 / 06 · Specs and answers
Spec sheet, fit check, answers
| Build | Double-ended realistic dildo, straight shaft |
|---|---|
| Tip to tip | 19.7" (50 cm) |
| Per half | 9.85" (25 cm), meeting at a molded seam with no gap |
| Thickness | 1.7" (4.3 cm), head to head |
| Weight | 706 g (24.9 oz; about 1.56 lb) |
| Ends | Realistic heads with a ridged glans; raised veins; skin-like texture |
| Material | Silicone: non-porous, odorless, solid |
| Flexes to | U, arch or S shapes; straightens after |
| Inside | Solid silicone, with no motor or battery |
| Base | Heads at both ends, so no flared base; no suction cup or harness base |
| Lube | Water-based |
| Age | Adults 18+ only |
| Cleaning | Warm water and mild soap or a toy cleaner, then air-dry |
Questions, answered
Is one end bigger than the other?
No. Each end is 9.85" (25 cm), and the width stays 1.7" (4.3 cm) the whole way.
If I bend it, does it stay bent?
It straightens again. A U, an arch or an S all relax back to a straight line, with no permanent kink.
Is it long enough for two?
That is what the 19.7" (50 cm) is for: one end per person. One person can use it alone as well.
Does it attach to anything?
No. There is no suction cup and no harness base. Both ends are heads, so hold on to it during anal play.
What is the cleaning routine?
Wash it before and after, with warm water plus mild soap or with a toy cleaner. It can go under a running tap, since there are no electronics. Then let it dry in the air completely.
Does it run on batteries?
No. There is no motor and no battery; it is solid silicone.
Will warm weather soften it?
No. Silicone keeps its shape in warm weather, even stored in a drawer.
It makes sense if
- Two of you want to share a single toy
- 1.7" thick is a size you already know you like
- Flexibility matters to you
- You prefer a toy that never needs charging
Better to pass if
- You are still working out your size
- A suction cup or harness base is essential to you
- You want vibration
- Your lube of choice is silicone-based





