Realistic Penis Sleeve Extender - 8.5" Silicone, +3.14" Length, +36% Girth, Built-In Cock & Ball Ring

The Ring Is What Holds It All Up

Whether an extender sleeve works or falls halfway short comes down to the ring. Here it is moulded into the same body, a single piece wrapping both penis and testicles, and it does two things at once: it anchors the sleeve so it does not travel during use, and it slows the blood coming back out, which keeps an erection firmer for longer. Without that anchor, a sleeve this size would shift.

Total length is 8.5 inches (21.6 cm), adding roughly 3.14 inches of reach and around 36% of girth from the moment it goes on. The outside is realistic, with sculpted veins and a defined head. The inside is a ribbed channel that works on the person wearing it rather than only the person receiving. The liquid silicone is super-stretch, soft, odourless and body-safe, so it accommodates most sizes without gripping at any one point. It is waterproof and reusable, rinsing clean under running water.

To fit it, put water-based lubricant inside the sleeve first, roll it up into place and seat the ball ring behind the testicles, then add more lubricant on the outside before anything starts. Because the ring restricts blood flow, take it off after 30 minutes at the outside, and immediately if there is numbness, tingling, discoloration or pain. Never use it asleep or under the influence of alcohol or anything else. Warm water with mild soap or a toy cleaner handles cleaning before and after; water-based lubricant only, air dried fully and stored clean and dry.

• 8.5 inches (21.6 cm) in total length
• Adds roughly 3.14 inches of reach and about 36% girth
• One-piece cock and ball ring built into the sleeve
• Sculpted veins and head outside, ribbed channel inside
• Super-stretch liquid silicone, odourless and body-safe
• Remove the ring after 30 minutes at the most

The sleeve and the lubricant it needs travel together on the same 69-minute run to any Miami Beach address.